BITUMEN VG20

    BITUMEN VG20


    Introduction of bitumen VG20

    BACCO Bitumen Grade VG 20 is a standard viscosity grade Bitumen usually used as paving Bitumen suitable for road construction and other industrial purposes. This grade of Bitumen is mainly used for hot mix, especially in moderate climates. 

     

     

     

    Typical properties

     

    Characteristics

    VG-20

    Test

    Kinematic Viscosity, 135˚C, CST, min

    1600

    IS1206

    Flashpoint, C, Max

    300

    IS1448

    Flashpoint, C, min

    220

    IS1448

    Solubility in trichloroethylene, %, min

    99.0

    IS1216

    Penetration at 25˚C

    60-80

    IS203

    Softening point, C, min

    45

    IS1205

    Tests on residue from thin film over test / RTFOT

    I. Viscosity ratio at 60˚C, max

    4.0

    IS1206

    II. Ductility at 25˚C, cm, min

    50

    IS1208

     

     

     

    Applications

    Bitumen VG-20 is used for paving in high-altitude regions & cold climates. Also, it can be used for producing some kind of asphalt primer and Waterproofing products.

     

     

     

     

    Hazard Identification

    NOT classified as dangerous in accordance with Directive 67/548/EEC or EC 1272/2008.

    The main hazards presented by Asphalt relate to the temperature of the material. The following hazards may apply:

    - Hot materials may burn the skin.

    - Fumes from Asphalt are unlikely to be hazardous when laid in open-air situations, but there may be a risk to health by continuous inhalation of high vapor concentrations which might arise in poorly ventilated, confined, or semi-confined spaces.

    - Asphalt is not a dusty material, but respirable dust may be released by cutting, drilling, or planning hardened asphalt. If inhaled in excessive quantities over a prolonged period or extended period, respirable dust can constitute a long-term health hazard.

    Dusts containing Respirable Crystalline Silica* (quartz) present a greater hazard. Long-term exposure to respirable dust can lead to respiratory system damage and disease. Respirable crystalline silica* has been associated with the lung disease silicosis.

    The quartz content of the product will vary and is related to the type of aggregate used in the production of the asphalt. Advice on the quartz content and other chemical information is available from the supplying unit.

     

    Fire Fighting Measures

    Suitable Extinguishing Media: Dry powder, foam.

    Unsuitable Extinguishing Media: Do not use water. CO2 is also not suitable.

    Special Exposure Hazards in Fire: Hydrocarbon fumes may be released, along with other hazardous combustion products including smoke.

    Special Protective Equipment for Fire Fighters: Proper protective equipment including suitable respirators or breathing apparatus must be worn.

     

     

    Handling and Storage

    Handling:

    Skin contact with the product should be avoided. Inhalation of fumes should be avoided as far as is reasonably practicable.

    If the formation of vapors is a risk, then additional ventilation should be provided. Handle away from sources of ignition and heat. Do not smoke, eat or drink during use.

    Storage:

    No special requirements. Asphalt is normally used upon receipt.

    Refer to the relevant Technical Data Sheet for the specific product.

     

    Cleaning

    Tools: Clean with kerosene and gasoline.

    Hands: Use a hand cleanser or kerosene followed by soap and water.

     

    Availability

    BACCO Bitumen Penetration Grade VG20 is available in:

    ·        Bulk

    ·        New Steel Drums (185 Kg) and (150 Kg)